Messages

1581

General Mach Discussion / Re: Movement of Z axis is great in down direction but is incorrect in Up direction

« on: December 01, 2018, 11:48:40 AM »

sounds like a Resolution/rounding Problem.

pls post a Screenshot of your

Config -> Motor Tuning -> Z-AXIS MOTOR MOVEMENT PROFILE Screen

1582

General Mach Discussion / Re: JogOn - Question/Problem - Macros

« on: December 01, 2018, 11:44:44 AM »

hello meshacnc1,

pls describe what you realy want to do.
sometimes there is more than one way to rome.

1583

Brains Development / Re: Brain writing on/off relay

« on: November 29, 2018, 02:18:01 AM »

i have tested the brain here, it works fine.

1584

Brains Development / Re: Brain writing on/off relay

« on: November 28, 2018, 02:27:48 PM »

ok, i am sorry to have this brain file thrown away.

you have to rebuild it of the screenshot.

it you have Trouble, let me know, then i will do a new brain file

1585

General Mach Discussion / Re: G31 won't follow feed rate

« on: November 27, 2018, 01:09:59 PM »

witch Motion Controller?

1586

General Mach Discussion / Re: Artsoft having issues - Can't use Search

« on: November 27, 2018, 01:07:47 PM »

@ Tweakie

this search Problem is for weeks now, i can not realy believe that somebody is working on this.
 

1587

General Mach Discussion / Re: Artsoft having issues - Can't use Search

« on: November 26, 2018, 04:32:07 PM »

that's because all the artsoft People are only intersted to make Money,
no interest to make any "free" Support.


because "free" Support is what this "Forum users" do for years.

"i know everything better mode off"

1588

General Mach Discussion / Re: 4th axis set up on B axis query

« on: November 26, 2018, 04:27:47 PM »

[

Just out of interest why is it not recommended to connect two axis (motor drivers) to the same pin?

why you do not have a chance to square the axis by homing

1589

G-Code, CAD, and CAM discussions / Re: G Code stops at 2nd line and requires a second push of Cycle Start

« on: November 26, 2018, 06:39:19 AM »

check your Settings in:

Config -> General Config -> Tool Change

1590

General Mach Discussion / Re: Control VFD/Spindle via Breakout board and mach3.

« on: November 24, 2018, 02:52:09 AM »

you can use spare Output from the B-axis and put a PWM to 0-10V converter
on that, then you have a Speed control.