Messages

1211

Screen designer tips and tutorials / Re: 2 lines of "VB" message to show

« on: June 17, 2019, 03:36:35 AM »

don't know a possibility to Show more than one line in Standard errorlabel.

but you can run a small code in macropump and Show Messages N and N-1 in two userlabels

Code: [Select]

Open "C:\Mach3\Lasterrors.txt" For Input As #2 ' Open to read file.
Do While Not EOF(2)
Line Input #2, FileData ' Read a line of data.
SetUserLabel(151,GetUserlabel(150)) ' save message N-1 to userlabel151
SetUserLabel(150,FileData)                ' save message N   to userlabel150
Loop
Close #2


1212

General Mach Discussion / Re: Mach3/MX4660 Zero-Plate Issues

« on: June 15, 2019, 11:07:53 AM »

so you have made

a link from +12V out to OPTO2
and connected your touch plate to Input4 ?

1213

General Mach Discussion / Re: Mach3/MX4660 Zero-Plate Issues

« on: June 15, 2019, 10:53:03 AM »

you are absolutly right, thank you for correction.

1214

General Mach Discussion / Re: Mach3 - MPG - Precise control as it is on an industrial CNC...

« on: June 15, 2019, 03:05:43 AM »

i use a 80€ XHC USB MPG on my Weyrauch, and does exacly the selected step's.

1215

General Mach Discussion / Re: Mach3/MX4660 Zero-Plate Issues

« on: June 15, 2019, 02:57:36 AM »

if you have a look to the Manual, you will see that I1-I4 are internal hardwire by an or gatter to the estop Input.

so you have to use one of the other Inputs.

1216

General Mach Discussion / Re: My stepcraft DL445 laser leaves a path

« on: June 14, 2019, 02:55:38 PM »

OK, one eye is a Little bit sad to hear, that you gave up, but only one eye.

1217

General Mach Discussion / Re: My stepcraft DL445 laser leaves a path

« on: June 14, 2019, 09:25:47 AM »

got some more documentation about Pins of laser Interface.

and sorry, i was wrong in an earlier reply M11P1 means Switch Output 1 ON

1218

General Mach Discussion / Re: My stepcraft DL445 laser leaves a path

« on: June 14, 2019, 09:14:31 AM »

next try.

1219

General Mach Discussion / Re: My stepcraft DL445 laser leaves a path

« on: June 13, 2019, 11:59:02 PM »

i will try to contact stepcraft to get more information

1220

Screen designer tips and tutorials / Re: LED not showing with transparency

« on: June 13, 2019, 02:09:08 PM »

or use a tranparent button