Dear Art, sascha once again.
I'm getting the "Darwin Buffer Error - Motions out of Bounds" error, when i click enable.
What i did:
Removed the old Mach4 installation
Installed the version 4.2.0.2673 Mach 4 Version, and it's licensed with a new ID
Installed the version Darwin Setup V2 2611, and under System Information i can see it's licensed
Installed the VCRedistX86 for vs2013.
But under System Information i can see only a Version of "1.2472" of the Darwin Plugin.
Can you help me with my error?
When i switch off my controller card and click then "Enable" the error is gone? WTF?
Thank you
Sascha