>>Axis 2 Estop capability disabled for homing
Axis Homing begins on Axis 2
Axis 2 Homed with 0 steps decel after switch
Homing Complete on slave motor 0
Hi:
The messages above show the switches are set backwards. The System "thinks" they are already made.
In Darwin, when you turn on your switch, you must make sure it light up as "active" only when pressed. Make sure
of this by using "negate signal" selection if required.
Then turn on the switch in Mach4 and MAKE SURE that "low active" is NOT selected. You must use Darwin to set the
proper level for "on", not Mach4, so Mach4 must be left as "High Active".
I suspect thats the problem with your homing. Now when it comes to enable/disable , I too have seen this but havent
troubleshot it for a while, it was a Mach4 bug early on, its possibel its not fixed, so for next version Ill test to see if I can
stop that behaviour.
Thx
Art