Hi:
>>When clearing the E stop, it is necessary to clear, set, then clear again before motion will be available.
Hmm. First report of this, doesnt happen on my system. I can move immediately after enable is pressed.
>> This is true in both Darwin and M4.
You mean in the config? Ill try to reproduce. But I cant image as yet why..
>>Pin mapping in the port setup appears to have some errors. On my system, port 2 input pins 5, 6, and 7 are also tied to pins 15, 13, and 12 respectively.
Ouch..Thx. Ill check that out, I havent used a port 2 as yet, I have only one. I may have screwed up a mask. Preciate the report.
>>In addition, my input pin 11 does not toggle with the actual input (probe).
This is also on Port2?
Thx
ARt