Hi Guys:
I created a inch profile and ran some speed tests, all seems well BUT I did find a glaring error on my part,
when coming out of EStop I wasnt syncing M4's position, so a "Speed too fast" could occur after an enable
operation. This version repairs that.
I ran several loops of G12I12 and G13I12's to check circles in high speed, I ran 40Khz at 350Inches/minute
and I cannot hear any trouble. Im running servo's which can hide small aberations, so I tested quickly on my
emco lathe as well which has steppers. All seems good so Im not sure whats up. Test this version if you have had
"speed too fast" errors, this will fix that up.
You only need to update the plugin , not the driver or dll in this update...
Thx
Art