Messages

2121

General Mach Discussion / Re: Retiring.

« on: April 23, 2007, 04:18:32 AM »

Benny,

You have created a wonderful place to visit and exchange ideas and knowledge.

Thank you for all your effort.

Graham.

2122

General Mach Discussion / Re: Write Wizard

« on: April 22, 2007, 02:34:40 PM »

Hi Malcolm,

email me your code and I will take a look at it.

Graham.

2123

G-Code, CAD, and CAM discussions / Re: Powermill to Mach3 post

« on: April 22, 2007, 08:22:16 AM »

The fanuc 6 one will be very very close. Try it.

2124

G-Code, CAD, and CAM discussions / Re: Powermill to Mach3 post

« on: April 22, 2007, 08:17:20 AM »

In what way?

2125

General Mach Discussion / Re: Save Work Offsets

« on: April 22, 2007, 04:40:02 AM »

You could set up an M code macro with a G10 in it that sets your offsets for you, that way they will never get lost and also you can enter the M code in all the programs that use that fixture offset.

E.g.

G10 L2 P2 Xnnn.nnn Ynnn.nnn Znnn.nnn

Graham.

2126

LazyCam (Beta) / Re: only smal part in mach3 3

« on: April 21, 2007, 05:20:55 PM »

No problem at all, it will work fine.

2127

LazyCam (Beta) / Re: Pulling my hair out

« on: April 21, 2007, 04:15:14 PM »

Just upgraded to 2.0.065 and it load fine.

Graham.

2128

LazyCam (Beta) / Re: only smal part in mach3 3

« on: April 21, 2007, 04:07:44 PM »

The Mach3 licence covers the basic LazyCAM, if you want the pro version of LazyCAM its $50.00 more

Graham.

2129

LazyCam (Beta) / Re: Pulling my hair out

« on: April 21, 2007, 03:51:48 PM »

It loads fine into my CAD system, no problems found in the file, but I can't get LCAM to load it correctly ether, I think this is one for Brian.

I have sent it to him for his comments.

Graham.
 

2130

LazyCam (Beta) / Re: Pulling my hair out

« on: April 21, 2007, 01:58:29 PM »

Post your .dxf file and we will have a look.

Graham.