Messages

1901

G-Code, CAD, and CAM discussions / Re: mach3mill error

« on: October 05, 2007, 02:20:24 AM »

Hi,

on line N8 your R and Z are the same, I think your Z should be Z-.1

Graham.

1902

Show"N"Tell ( What you have made with your CNC machine.) / Re: 4th axis carvings

« on: October 03, 2007, 10:28:25 AM »

My guess, handles for fishing rods.

Graham.

1903

Show"N"Tell ( What you have made with your CNC machine.) / Re: 4th axis carvings

« on: October 03, 2007, 08:24:09 AM »

Wow, they look amazing.

Graham.

1904

General Mach Discussion / Re: where do I start??

« on: October 02, 2007, 08:53:04 PM »

Hi Chris,

after reading your last post about it been a hard cut, I would try the same cut on a short billet and check the results, 6" long on a tiny machine, it could be pulling the work into the tool.

Rule of thumb is, 3 times diameter is the maximum amount to be stuck out unsupported.

Graham.

1905

Newfangled Solutions Mach3 Wizards / Re: Tool Number read from Mach's Tool Table?

« on: October 01, 2007, 04:57:33 AM »

I have not found one for doing that.

Graham.

1906

Newfangled Solutions Mach3 Wizards / Re: Tool Number read from Mach's Tool Table?

« on: September 30, 2007, 05:33:55 AM »

You can get the data like this :-

GetToolParam(SHORT toolnum, SHORT param) for tool parameters. Param numbers are 1 - n and correspond to the tool window in the mill or turn modes.

In turn for example, 1 is TipDia, 2 is Tip Radius..ect..

Graham.

1907

Show"N"Tell ( What you have made with your CNC machine.) / Re: Celtic Cross from cherry wood

« on: September 29, 2007, 06:17:56 PM »

Nice, very nice.

Do you mean the knot work was done by hand.

Graham.

1908

General Mach Discussion / Re: ATC for lathe

« on: September 29, 2007, 06:09:52 PM »

Hi Chris,

Here is the latest version with the mods you asked for, anything you altered in the original will need to be changed.

I have added the return to absolute mode and a variable to set the lock back to pawl distance.

Graham.

1909

LazyCam (Beta) / Re: Pocketing Problem - File attached

« on: September 28, 2007, 06:02:16 PM »

No comment,

Graham.

1910

LazyCam (Beta) / Re: Pocketing Problem - File attached

« on: September 28, 2007, 05:51:23 PM »

I can not get LCAM to process it, my cam system AlphaCam did it and it generated 150,00 lines of code, maybe that's why LCAM struggled, here is the code, it may not be as you wanted.

Graham.