Messages

1461

Works in progress / Re: Another new screen

« on: January 05, 2009, 06:50:36 PM »

Shiznit, very American, use it

Graham

1462

Works in progress / Re: Another new screen

« on: January 05, 2009, 12:06:48 PM »

Ocean Blue ?

Graham

1463

Works in progress / Re: New 4 Axis Milling Screen Set (RaspScreen)

« on: January 04, 2009, 07:58:13 PM »

Here is the latest version of my screen set, its still not complete but its getting there.

Just extract the zip file to your hard drive C: or where ever you have Mach3 located.

Graham

1464

G-Code, CAD, and CAM discussions / Re: G12 Problem

« on: December 29, 2008, 02:59:16 PM »

Try the code like this

Graham


O540 (40th wide pad)
g0 z.004
g1 z-.004
g12 I.004
g0 z.1
m99

1465

General Mach Discussion / Re: Mach Workshop at Cabin Fever Expo

« on: December 29, 2008, 04:42:37 AM »

Doh! just wasted my spending money on factor 20    Oh well out of the freezer and into the fridge, never mind 

Graham

1466

SmoothStepper USB / Re: Some information about port 2

« on: December 28, 2008, 02:53:00 PM »

you should be able to connect this with a 5 volt supply and connect it straight to the breakout board.

Or have a look at these, these work even better

http://homanndesigns.com/store/index.php?main_page=product_info&cPath=15&products_id=30

Graham

1467

VB and the development of wizards / Re: Simple SetDRO Script Q?

« on: December 28, 2008, 10:35:45 AM »

Certain DRO's are read only, I think that is one of them.

Graham

1468

Tangent Corner / Re: Careful where you put your tattoo's!!!

« on: December 27, 2008, 08:08:11 AM »

That reminds me of the lady who loved Robert Redford and adored Burt Reynolds.  To show her love for them she had a big letter R tattooed on her left butt cheek and a big letter B on the right.

When she bent over to show people, they asked, who's RoB ?

Graham

1469

General Mach Discussion / Re: Denford Micromill 2000, Denford Microlathe

« on: December 27, 2008, 03:54:30 AM »

Yes, that should not be a problem. Mach3 runs pretty much ISO g-code so will run code from most CAM systems.

If you look in the downloads section at the top of the site you will find a Mach3 Mastercam post processor for version 9.

Graham

1470

General Mach Discussion / Re: Denford Micromill 2000, Denford Microlathe

« on: December 26, 2008, 02:43:40 PM »

I would have thought so,

3 * Gecko G251 @ $69.00  http://www.geckodrive.com/product.aspx?c=3&i=14471

1 * CNC4PC C11G @ $109.00  http://www.cnc4pc.com/Store/osc/product_info.php?cPath=33&products_id=46

and your time and this forum.

Graham