Messages

781

VB and the development of wizards / Re: Saving VB-Scripts

« on: November 01, 2019, 07:48:57 PM »

Remove the script from the button and put it in the M6Start.M1S macro for your selected profile.

782

General Mach Discussion / Re: Cutting wrong dimensions in only one spot

« on: October 31, 2019, 10:40:29 AM »

That Gcode is producing the black line perfectly by the look of it.

783

Mach4 General Discussion / Re: Probe not matching with edge finder when measuring Y

« on: October 31, 2019, 09:59:35 AM »

place your setting ring at the farthest most point of the machine in X&Y from the home position, this on most machines is the least used place so is the lease worm part of the screw and slides. calibrate there and then edge find there.

If you find the same errors then its time for a new machine.  End of problem.

784

Mach4 General Discussion / Re: Probe not matching with edge finder when measuring Y

« on: October 31, 2019, 06:46:29 AM »

You could always have the machine laser aligned and mapped but the backlash is your main issue, to maintain the accuracy you think you need your machine mechanics need to be a power of 10 better, so you are not going to get it.

 

785

Mach4 General Discussion / Re: Probe not matching with edge finder when measuring Y

« on: October 30, 2019, 08:58:13 PM »

Is the error reversed if you probe the opposite face?

Also is there an error in the other axis?

Have you another gauge ring you can measure, the other may be oval

786

General Mach Discussion / Re: Mach3-The machine stop in execut program

« on: October 30, 2019, 08:46:20 PM »

If you are using the Licence that came with the board then it will always fail to work.

787

General Mach Discussion / Re: Cutting wrong dimensions in only one spot

« on: October 26, 2019, 08:10:09 PM »

Are you using tool comp?

788

General Mach Discussion / Re: Cutting wrong dimensions in only one spot

« on: October 26, 2019, 12:49:06 PM »

Are you cutting this on a mill or router type machine?

789

General Mach Discussion / Re: Cutting wrong dimensions in only one spot

« on: October 26, 2019, 08:16:46 AM »

How is it being measured, 3 or more points on an arc or a digitised path?

790

Tangent Corner / Re: Cam lobe generator ?

« on: October 24, 2019, 03:47:46 PM »

I knew you could do it