Messages

771

General Mach Discussion / Re: A-axis static feed + Spindle rpms

« on: November 21, 2019, 06:55:19 AM »

Is your spindle controlled by a 0-10V or PWM signal?

Not sure what you are asking about the 4th axis feed

772

General Mach Discussion / Re: cheap 4 axis controler on ebay

« on: November 21, 2019, 06:51:35 AM »

Some work and some do not, its better to pay a bit more and get a known brand

773

General Mach Discussion / Re: No movement on new computer.

« on: November 20, 2019, 07:42:05 PM »

Have you selected the motion controller form the menu?

Have you checked it is licenced in the help menu?

774

G-Code, CAD, and CAM discussions / Re: Mach adding tool offset twice

« on: November 17, 2019, 06:47:23 PM »

Why would you want a peck depth of Q0?

775

Mach3 and G-Rex / Re: Index and timing in M3-Turn

« on: November 16, 2019, 02:51:43 PM »

You only need the index

776

Mach3 and G-Rex / Re: Index and timing in M3-Turn

« on: November 15, 2019, 07:02:35 PM »

If you use timing only one slot needs to be wider so mach can use it as the trigger.

777

General Mach Discussion / Re: 4th axis issue (newbie)

« on: November 15, 2019, 06:59:52 PM »

You need to post some screen shots of your settings, 4th should move independant of any other axis, you may have it slaved to X by mistake.

778

Mach4 General Discussion / Re: Mach4 Hobby Screen Editor

« on: November 06, 2019, 07:07:32 PM »

Mach4 has to be in 'Disabled Mode' but the option should still be on the menu even if 'Enabled' but it will be greyed out

779

General Mach Discussion / Re: 4th axis issue (newbie)

« on: November 03, 2019, 09:02:41 PM »

Check the Ports and Pins, Motor Outputs under the Config menu and see if you have 4 axis configured and if yes then is it A,B or C that is ticked.

Once you know this you can go to MDI and type G00 G91 A90, B90 or C90 and the axis should move.

780

VB and the development of wizards / Re: Array G-Code Macro

« on: November 02, 2019, 07:59:57 PM »

Check out the G52 command.