Messages

581

General Mach Discussion / Re: MACH3 stalls on M3 command

« on: June 25, 2020, 08:19:32 PM »

Only time I have seen this is when Mach is waiting for the spindle to reach speed, so make sure feed back is working or if you do not have feedback turn off closed loop and feedback.

Or it could be none of this.

582

Mach4 General Discussion / Re: Custom ATC M6 not running

« on: June 25, 2020, 08:07:51 PM »

Mach4 Lathe uses T0101 NOT T1 M6

583

Mach4 General Discussion / Re: Mach4 M19 Spindle Orientation on a Mill

« on: June 25, 2020, 08:04:49 PM »

You have to add the threading module to do that.

584

Third party software and hardware support forums. / Re: MB3 Breakout Board Power Supply

« on: June 21, 2020, 06:13:35 PM »

Have you set the 3 jumpers on the ESS correctly and you have the 24V going into the MB3 at the corner of the board.  Also check the fuse on the board.

585

Mach4 General Discussion / Re: EMCO 6P CNC retrofit - M6 Issue

« on: June 20, 2020, 07:16:08 PM »

Great stuff, 

586

Mach4 General Discussion / Re: Advice for getting my CNC software back up to date?

« on: June 20, 2020, 07:07:04 PM »

Don't fix what ain't broken.

587

General Mach Discussion / Re: PDB issue Mach 3 ATC

« on: June 20, 2020, 07:04:26 PM »

There is far more to this than just a screen set, there are images and macros too.

588

General Mach Discussion / Re: PDB issue Mach 3 ATC

« on: June 19, 2020, 08:20:40 AM »

So the M6Start.mcc is not a Mach3 file, so we need your M6Start.m1s file from your working profile.

Do you have a tool change page on your screen, if so post a picture of that too.

589

General Mach Discussion / Re: PDB issue Mach 3 ATC

« on: June 19, 2020, 08:06:31 AM »

Are you running Mach3 or Mach4 because you have files from both here M6Start.mcc is compiled Mach4 Lua and M131.m1s is Visual Basic from Mach3

590

Third party software and hardware support forums. / Re: MB3 Breakout Board Power Supply

« on: June 18, 2020, 10:19:21 PM »

It should be fine, the rating us usually the minimum requirement for reliable use, you could put a 3A fuse in line to the board to stop any faults cooking the board.