Messages

731

Mach4 Plugins / Re: Stupid Vista Plug in, S and V reversed

« on: February 11, 2020, 07:02:04 PM »

Swaping the wires in the pendant would work

732

FAQs / Re: Auto Tool Zero Problem

« on: February 10, 2020, 06:46:37 PM »

Well you have then all ticked as on so turn them off if you are not using them

733

FAQs / Re: Auto Tool Zero Problem

« on: February 10, 2020, 06:23:41 PM »

Ok, so estop will be going into pin 13, so your probe has to go in 15, if 15 is used for something else then you have to start linking all your home switches and limit switches into a single daisy chained input to free up one of the input pins.

734

FAQs / Re: Auto Tool Zero Problem

« on: February 10, 2020, 06:12:02 PM »

I now see you have no estop, that is not good.

So set the probe into pin 15 and change the ports and pins probe input to 15 and as long as you have nothing else on pin 15 it should work

735

FAQs / Re: Auto Tool Zero Problem

« on: February 10, 2020, 06:06:03 PM »

You have your homing and limits on Pins 10,11 & 12 so they can not be used for a tool setter so that leaves 13 & 15 one should be estop and what is the other

736

FAQs / Re: Auto Tool Zero Problem

« on: February 10, 2020, 04:53:08 PM »

Ok, so we need some pictures of your breakout board and the settings pages in mach to work out what is going on.

737

Mach4 General Discussion / Re: Problems - Win10 update + PMDX_424 + LUA

« on: February 08, 2020, 08:50:33 PM »

The problem is that some plugin code in the back of the screens was updated to reflect the new Lua version which can in some cases break custom screen sets.

It all depends how custom your screen set is.

You can replace your old screen set Lua code with the new Lua code from the latest std screen set and hope for the best.

If that fails its time to redo your screen set using the latest std screen set as a template.

738

Mach4 General Discussion / Re: Problems - Win10 update + PMDX_424 + LUA

« on: February 08, 2020, 08:11:16 PM »

I would try one that was installed with that version of Mach4, a lot has changed in the Lua versions in the last 2 years.

739

FAQs / Re: Auto Tool Zero Problem

« on: February 08, 2020, 07:59:34 PM »

What happens if you change it onto pin 15

740

General Mach Discussion / Re: Mach3 turn threading problem with Z feedrate

« on: February 08, 2020, 07:35:48 PM »

Too much de-bounce can also be a problem.