Hello Guest it is March 28, 2024, 10:55:36 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Graham Waterworth

741
Mach4 General Discussion / Re: Index pulse and Spindle RPM?
« on: January 02, 2020, 07:16:55 PM »
I have just noticed you are using a CS-Labs I am using ESS so the setup is different, ignore my rambling


742
Mach4 General Discussion / Re: Index pulse and Spindle RPM?
« on: January 02, 2020, 02:37:41 PM »
Have you tried my suggestion ?

743
Mach4 General Discussion / Re: Index pulse and Spindle RPM?
« on: January 01, 2020, 01:19:14 PM »
I once had a similar issue with a lathe, I ended setting the de-bounce to zero.

744
VB and the development of wizards / Re: macro to call g54 and g55, etc
« on: December 28, 2019, 08:20:13 PM »
Why do you have to deactivate the Z and A axis?

If they are not commanded in the g-code they will not move anyway

745
It has been passed on to technical for there comments.  May be a few days due to holiday.

746
Is the collision when the tool returns to the last depth ready to do the next peck cut?

747
General Mach Discussion / Re: CNC XPro4
« on: December 24, 2019, 07:08:45 PM »
Common faults are:-

Board is not enabled.

Boards works at 3.3V,  Mach needs 5V.

Board needs more than one power supply.

Check if inputs need to be at 0V or 5V.

748
Mach4 General Discussion / Re: PCNC 1100, Mach4 /ESS, Spindle Speed Control
« on: December 20, 2019, 07:47:24 PM »
Spindle drives need the motor settings in Mach to be set to 1000 steps and 1500 velocity and then the output pin to be any pin you have spare this is then the feed for the spindle input signal.  You also have to set the in and max spindle speed in the pulleys table.

749
General Mach Discussion / Re: re- hall of shame
« on: December 20, 2019, 07:31:54 PM »
There is only one safe way to get a genuine copy of Mach3, buy it from the Artsoft web site.

750
Mach4 General Discussion / Re: Mach 4 screen sets
« on: December 14, 2019, 09:05:57 PM »