1901
General Mach Discussion / Re: Strange toolpath
« on: October 15, 2007, 08:21:22 AM »
In what way is the 2nd path wrong?
The only thing I can see wrong with the code is that Mach has no reference to the tool size for the G41's, you need to put a Px.xx or a Dnn
Where x.xx is the tool diameter and nn is a tool number for the offset containing the tool diameter.
If you have programed allowing for the tool size then the G41's are not needed.
Graham.
The only thing I can see wrong with the code is that Mach has no reference to the tool size for the G41's, you need to put a Px.xx or a Dnn
Where x.xx is the tool diameter and nn is a tool number for the offset containing the tool diameter.
If you have programed allowing for the tool size then the G41's are not needed.
Graham.