2911
General Mach Discussion / Re: Z axis on/off
« on: May 26, 2006, 04:41:11 PM »
Put code in the MacroPump.m1s like this:
if(GetDRO(2 < 0.0 ) Then
ActivateSignal(Output1)
else
Deactivatesignal(Output1)
end if
There is a Wiki on the support page telling how to do a Macro pump under the Modio.. Hope that helps
Brian
if(GetDRO(2 < 0.0 ) Then
ActivateSignal(Output1)
else
Deactivatesignal(Output1)
end if
There is a Wiki on the support page telling how to do a Macro pump under the Modio.. Hope that helps
Brian