Messages

1181

General Mach Discussion / Re: It's Alive! (El Cheapo Dyna 2400 Mach III conversion)

« on: May 08, 2007, 07:19:45 PM »

Jeff,
The last one that I did i had to use Sherline mode to make it run right

Just wanted you to know that before you started!
BTW Nice mill 

Later
Brian

1182

General Mach Discussion / Re: Keygrabber problem, (can't find DLL)

« on: May 08, 2007, 07:17:10 PM »

we could get you the DLL but you will need to tell us what it is

1183

General Mach Discussion / Re: servos not traveling proper distance, new install of 2.0

« on: May 08, 2007, 04:34:11 PM »

You have an encoder noise problem Do you have a scope to test with?

1184

General Mach Discussion / Re: skipping steps

« on: May 08, 2007, 03:31:35 PM »

No problem It happens to me from time to time 

1185

General Mach Discussion / Re: skipping steps

« on: May 08, 2007, 03:12:59 PM »

on the diagnostics page you will see this button...

1186

General Mach Discussion / Re: skipping steps

« on: May 08, 2007, 02:00:46 PM »

Did you test it with the toolpath off?

1187

LazyCam (Beta) / Re: LazyCam 2 Pro Turn Error?

« on: May 08, 2007, 12:39:25 PM »

That is a known bug and is fixed for the next rev Should be out tonight or tomorrow.
Thanks
Brian

1188

General Mach Discussion / Re: servos not traveling proper distance, new install of 2.0

« on: May 08, 2007, 12:37:24 PM »

Read your docs about setting your Gain and Dampen pots on the back side of the drives...

Also can you turn the shaft by hand with the servo on?

1189

General Mach Discussion / Re: Keygrabber problem, (can't find DLL)

« on: May 08, 2007, 11:07:42 AM »

what DLL is it looking for ?

1190

General Mach Discussion / Re: servos not traveling proper distance, new install of 2.0

« on: May 08, 2007, 10:11:12 AM »

what are you running for servo drives?