Messages

1621

LazyCam (Beta) / Re: relocating x0 y0 start position

« on: February 01, 2007, 09:42:39 PM »

The problem is that the Graphics card in the computer I think we may need to stop all updates to the screen...

I will tell Art about it and we will see what he and I can come up with

Thanks for the info
Brian

1622

General Mach Discussion / Re: Motors turn in Kcam, but not mach. What on earth am I doing wrong?

« on: February 01, 2007, 09:39:18 PM »

Sherline mode Try that... you may not even be tripping the Opto's

1623

General Mach Discussion / Re: Spindle Calibration Function?

« on: February 01, 2007, 09:36:15 PM »

What RPM are you running?

1624

General Mach Discussion / Re: New CV features

« on: February 01, 2007, 09:34:57 PM »

Slow down and you should not round as much...  You need better accels But I don't think your machine could ever take it!

BTW what are you running for hardware? Machine and control hardware.

1625

General Mach Discussion / Re: Stepper's spinning with glitch'es

« on: January 30, 2007, 07:14:09 PM »

Daniel
This is going to be a pain in the butt to TRY to make that work... the problem is that your laptop is changing the voltage to your processor and changing the speed of the processor! We CAN"T fix Mach 3 until you get that to stop! After you do that (I wish you good luck) it "should" work...

1626

General Mach Discussion / Re: Wait on Hypertherm XFER output?

« on: January 30, 2007, 07:09:06 PM »

You are going to have to make an Mcode to do that I would put a SystemWaitFor() .. Check out the Mach2 Customization Doc for details on how to use it.

Hope that helps
Brian

1627

Newfangled Solutions Mach3 Wizards / Re: cut rectangle wizard

« on: January 29, 2007, 03:22:32 PM »

It is in the newest version of Mach3

1628

Newfangled Solutions Mach3 Wizards / Re: cut rectangle wizard

« on: January 29, 2007, 02:18:53 PM »

Okay, I am done !

Check it out , it is in there

1629

General Mach Discussion / Re: x axis mounted and working, y & z stalling!

« on: January 29, 2007, 01:24:24 PM »

Steve try Sherline mode... Could you tell me who got the driver box from?

1630

General Mach Discussion / Re: Setup estop, spindle on/off, and Xylotex 3 axis drive

« on: January 29, 2007, 01:19:06 PM »

Great! I knew it was going to be some simple thing

Have fun with your machine!