Messages

991

General Mach Discussion / Re: Conversion Bridgeport Mills

« on: June 25, 2007, 02:32:46 PM »

You should be able to install Mach3 on the Machine with the Galil card and it should run after you set your motor tunning

If you need help please mail me or post here on the forum
Thanks
Brian

992

General Mach Discussion / Re: Schematic for slo-syn SS2000D6 drive or replacement

« on: June 24, 2007, 09:26:03 PM »

Have a look at Gecko Drive and see if they will run your motors

Thanks
Brian

993

General Mach Discussion / Re: THC 300 pin help PLEASE???

« on: June 24, 2007, 09:24:23 PM »

You will need to talk to the guys that are selling the THC300  They know the best settings to get it all working for you.
Thanks
Brian

994

Galil / Mach3 and Galil ... Getting better

« on: June 17, 2007, 12:38:58 AM »

Hello Galil people...
I have been working for a router OEM on a galil for the past few days and I must say that I have it working better now then EVER!!!! I am running 3 axis and a tool changer (wine rack) .I will release a new plugin after I get back home, I think it will get everyone all fixed up .

995

General Mach Discussion / Re: VB Script re G68 to edge find

« on: June 14, 2007, 11:32:05 PM »

it is not that simple You are better to get the vetor of the line ... after you have the vector you need to offset the points to the side that you get the 3rd point from. At this point I could add code to offset the dist of the plate and so on... I will be able to offset the Dia of the ball at the end of the probe.... I don't see a problem with all this!
Brian (I just need to get a better probe)

996

General Mach Discussion / Re: When in MACH3 motors begin to move ?

« on: June 14, 2007, 11:27:09 PM »

Please check the motor ports and pins settings....

Thanks
Brian

997

General Mach Discussion / Re: VB Script re G68 to edge find

« on: June 14, 2007, 11:15:19 PM »

The math for me is very simple... I will do it all with vector math, I have done all the math needed to solve the problem but the code is in Lcam I will just pull the code from Lcam and put it in the plugin... That should do it

998

General Mach Discussion / Re: VB Script re G68 to edge find

« on: June 14, 2007, 11:09:41 PM »

I was taling to an OEM and I think it is time to add this to a plugin... It is just more then I think I would like to do in VB! It will require more math then anyone would think

Thanks
and it should be soon...

Brian

999

General Mach Discussion / Re: What is a good feed rate?

« on: June 11, 2007, 11:38:26 AM »

Set your direction prechange to about 10 and the step pule to 10 on the motor tuning page... That should help (I hope)

1000

General Mach Discussion / Re: event driven serial control and modbus

« on: June 11, 2007, 10:03:29 AM »

I think you are the first to do that ..

I will ask Art about it this week

Thanks
Brian