Messages

1061

LazyCam (Beta) / Re: Lcam Rev 2.02

« on: May 29, 2007, 11:15:23 AM »

The Extra lines in the drawing is a bug in the importer code..
We have a bug report to the place that is doing the DXF importer code... if we don't hear from them soon we will bump them again...

Once that is fixed we will work on the offset code

1062

General Mach Discussion / Re: Spindle won't stop on reset

« on: May 29, 2007, 09:02:12 AM »

The esc Key is not something that you should  use The Esc key is hard coded into the software as a STOP NOW in Gcode moves... I would  use the ~ key.
Thanks
Brian

1063

General Mach Discussion / Re: Proportional control Joystick

« on: May 29, 2007, 08:43:11 AM »

any that work in windows will work

1064

General Mach Discussion / Re: Configuraton not saved

« on: May 29, 2007, 08:41:38 AM »

Yes, you need to rest your motor steps per unit, accel and Vel settings. also please select the units that you are going to set the machine up with under Config/Units

That should get you what you need.
Brian

1065

General Mach Discussion / Re: Spindle won't stop on reset

« on: May 28, 2007, 10:54:52 PM »

You will need a DoSpinOFF()

That should do it

1066

General Mach Discussion / Re: Proportional control Joystick

« on: May 28, 2007, 10:51:26 PM »

It will do proportional if you use a joystick that is  proportional... it will not work with keygrabber.

1067

General Mach Discussion / Re: Configuraton not saved

« on: May 28, 2007, 10:48:36 PM »

What setting?

1068

General Mach Discussion / Re: Mach-3 font size

« on: May 28, 2007, 10:47:51 PM »

Can you get any help from the the people that made to screen set ? If not I will see what I can do to help..

Thanks
Brian

1069

LazyCam (Beta) / Re: Lcam 2.0...

« on: May 28, 2007, 10:36:38 PM »

AskMan
Lcam  should do that now...  you select the outer chain and tell it to pocket and you are done

1070

LazyCam (Beta) / Re: Lcam 2.0...

« on: May 28, 2007, 10:35:06 PM »

Docltf
I have found the problem and is fixed for the next rev

Thanks
Brian