Messages

1021

General Mach Discussion / Re: Wiki vandalism outbreak

« on: June 03, 2007, 05:48:38 PM »

Thank you John. I didn't see it... You are to fast

1022

General Mach Discussion / Re: Mach & Multi Tool Head

« on: June 03, 2007, 05:45:10 PM »

The best way to do the FRO in your case is to use a ModIO . this will also giveyou the IO that you need for this project

Yes you can write a macro in the M6 to change tools and set the offsets... there are a few guys that will write the code for you for a $$$  and if they can't do it I can have a look at it... OR you can post here and we will teach you a bit of VB (not much fun but gives you the power )

Hope that helps
Brian

1023

LazyCam (Beta) / Re: text engraving

« on: June 03, 2007, 05:39:57 PM »

You will need to explode the text into line segments... that should do it

1024

LazyCam (Beta) / Re: Cann't find Mach3

« on: June 03, 2007, 05:39:07 PM »

Should be fixed in the new rev... it is on the web now

Thanks
Brian

1025

General Mach Discussion / Re: CV Problems / Losing steps

« on: June 03, 2007, 05:35:55 PM »

Tested okay here ... Could you post your XML so I can see your settings?

1026

General Mach Discussion / Re: CV Problems / Losing steps

« on: June 03, 2007, 05:04:29 PM »

Woud you please test it You k now how Brett can get

1027

LazyCam (Beta) / Re: LCam display size ?

« on: June 03, 2007, 04:42:10 PM »

The problem is that I will not write it down and will not remember what I worked on... Some of the stuff that I am working on you will not see for a few months I wish it were so simple

1028

LazyCam (Beta) / Re: Lcam 2.0...

« on: June 03, 2007, 01:19:10 PM »

No trouble I was thinking that it was not working ... so it is good news all the way around 

1029

General Mach Discussion / Re: CV Problems / Losing steps

« on: June 02, 2007, 09:00:16 PM »

Brett will test it and he can send it to me


He has a stepper mill

1030

General Mach Discussion / Re: CV Problems / Losing steps

« on: June 02, 2007, 08:56:24 PM »

I can test the file here on the servo mill that I have here as well