Messages

2351

General Mach Discussion / Re: Art of CNC as DRO

« on: August 25, 2006, 11:42:50 AM »

You could use the Grex.. .but the DRO's are too slow... The new firmware will fix this

2352

General Mach Discussion / Re: erratic behavior on servo machine

« on: August 25, 2006, 11:39:26 AM »

Be sure that you hook only one end of the shield to ground!

2353

General Mach Discussion / Re: THC300 arc voltage

« on: August 25, 2006, 11:35:36 AM »

You may have to mail Jim C for that one

2354

Newfangled Solutions Mach3 Wizards / Re: Cut Gears alteration

« on: August 24, 2006, 01:05:58 PM »

I will see if I have time to program it at some point.. I just don't have the time to give you at the moment On the other hand there are more people (in mach) that will cut there gears with an  involute cutter... You are the first one that I have seen that wanted to use a gear hob. if there are others that are going to use it, I can take more time to work on it....


Thanks

2355

General Mach Discussion / Re: erratic behavior on servo machine

« on: August 24, 2006, 01:00:17 PM »

I have never seen that.. but I have seen encoder counts that have gotten lost due to noise on the encoder lines.

Hope that helps
Brian

2356

General Mach Discussion / Re: Text Wizard

« on: August 24, 2006, 12:58:31 PM »

This is an arc error Add a G90.1 and you should be okay

2357

General Mach Discussion / Re: Art of CNC as DRO

« on: August 24, 2006, 12:55:26 PM »

Ron sells a board that will take the encoder in I can't seem to find ron's web page but Hope some one here can post it ...
Thanks
Brian

2358

LazyCam (Beta) / Re: lazycam

« on: August 24, 2006, 07:08:51 AM »

There is a doc in the zip file on the web... IF you need more info then that please tell me and I will work on writing it

2359

Newfangled Solutions Mach3 Wizards / Re: Cut Gears alteration

« on: August 23, 2006, 05:57:38 PM »

After I looked into the the code... I can tell you that it will take a rewrite of the wizard I can't take the time at this point in time...

2360

Newfangled Solutions Mach3 Wizards / Re: Cut Gears alteration

« on: August 23, 2006, 05:42:41 PM »

John you need to set the tool Dia in the Tool set up screen

if you do that I think you will be all set ...