Messages

1571

LazyCam (Beta) / Re: Toolpath Display Query

« on: February 12, 2007, 03:12:19 PM »

IT is not that simple but I can see why you would like to have that... I put it on the board

1572

LazyCam (Beta) / Re: lazy cam and auto cad

« on: February 12, 2007, 03:11:25 PM »

See if you can export it as an autocad rev 12DXF ... I don't know autocad.. never used the stuff.

1573

General Mach Discussion / Re: recomend a relay?

« on: February 12, 2007, 03:08:52 PM »

I like to use Zero crossing SSR's. they are about 14.00 each and will take the full load of the pump (up to 10-20 amps)

I go the last one from MSC (I had to make the order for some other stuff at the same time)

1574

General Mach Discussion / Re: enhanced pulsing

« on: February 12, 2007, 03:06:50 PM »

Yes you need that all the time I think we should take it out and just hard code it ON

1575

General Mach Discussion / Re: Licensing & Conversational

« on: February 12, 2007, 03:04:54 PM »

Hood I like how you put that and could you please post for me! Your post sound better then mine... I think I do them to fast...

1576

General Mach Discussion / Re: Strange Behaviour

« on: February 12, 2007, 02:59:57 PM »

What is in your help /about  licence name? I bet you see demo mode

1577

General Mach Discussion / Re: motors gone mad with new computer

« on: February 11, 2007, 08:54:44 PM »

You may be able to use the PMDX-103 and save a bit of work

1578

LazyCam (Beta) / Re: Lazycam arcs output bug ?

« on: February 11, 2007, 10:29:22 AM »

I have not been feeling well for the past few days and I am headed to CA for a week after that... so I don't think I am going to have time to dig into the Arc directions... I can tell you that I did go over that with code from Cam software. that is not to say that the cam software didn't put out the code in the wrong direction... I will have a look at it, but you are the only one to report this as a bug

Later
Brian

1579

Show"N"Tell ( Your Machines) / Re: Eagle KM-750..Anilam Crusader GX-M

« on: February 11, 2007, 10:24:41 AM »

Chad you are looking old today

1580

Show"N"Tell ( Your Machines) / Re: Bender

« on: February 11, 2007, 10:23:12 AM »

Walt,
You need to have a plugin to take in the Inverntor file and turn it into Gcode I had no idea that you could get a list like that from autodesk!