Messages

2731

General Mach Discussion / Re: Freezing! Mach3Version D1.90.035 to 50? What's different from vn17?

« on: June 23, 2006, 07:15:41 AM »

update to the lates rev of Mach3 and see if you still have the probelm... I loaded your XML and couldn't get the error

Thanks
Brian

2732

General Mach Discussion / Re: 50 in/min but no faster

« on: June 22, 2006, 11:14:10 PM »

You can threadmill any thread you like


Did you lower the accel and see what the effect is?

2733

General Mach Discussion / Re: 50 in/min but no faster

« on: June 22, 2006, 07:33:07 PM »

Sounds like you have a smaller servo system... 30V is not a very high voltage for a servo system, did you make the drive system or did it come with the router?

2734

General Mach Discussion / Re: Missing Steps

« on: June 22, 2006, 07:29:09 PM »

Bob's board will fix the problem of a low voltage printerport


I think you should look into the optimization and see if there is something in there that is making the spikes..

Thank you
Brian

2735

LazyCam (Beta) / Re: lazycam

« on: June 22, 2006, 01:58:30 PM »

It should be all fixed

2736

General Mach Discussion / Re: 50 in/min but no faster

« on: June 22, 2006, 01:57:17 PM »

Mach3 has less phase jitter than mach2... So you should get better speed out of mach3

2737

General Mach Discussion / Re: Missing Steps

« on: June 22, 2006, 01:52:23 PM »

Could you pleae run a driver test and tell me what you see?

2738

General Mach Discussion / Re: ReactOS and Mach3

« on: June 22, 2006, 07:14:18 AM »

It will only run on XP or 2000

Thanks
Brian

2739

LazyCam (Beta) / Re: suggestion

« on: June 21, 2006, 08:56:30 PM »

It is in
If you put a line Inc of 5 it will do the following

N5
N10
N15
N20 ....


If you have an Inc of Zero it will not put in the line numbers (that is how I line it )

hope that is what you were looking for
Brian

2740

General Mach Discussion / Re: Freezing! Mach3Version D1.90.035 to 50? What's different from vn17?

« on: June 21, 2006, 08:53:32 PM »

Could you post your XML ? i would like to see if my system is going to call the hidden script

Thank you
Brian