3261
General Mach Discussion / Re: Getting New Installation Going
« on: April 06, 2006, 11:13:50 AM »
The XML's are in the Mach2/3 Dir
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
If I tell it to move 2" it moves 2", If I tell it to make a 3" diameter circle it makes a 3" diameter circle. The problem is that if I tell it to make that circle in 1 minute it takes about 2 minutes. Both the X and Y axis are set at 180 ipm with an acceleration of 3"/sec^2.3"/sec^2 is about half what I run ... Could you please post your XML file?