Hello Guest it is December 04, 2021, 09:22:11 PM

Author Topic: Maping I/O on G100?  (Read 3990 times)

0 Members and 1 Guest are viewing this topic.

Maping I/O on G100?
« on: April 05, 2006, 02:29:53 AM »
Hello again,
I got my motors running on my G-rex, thanks to the video's and G-rex for dummies document.
The motors runs very fast and smooth. But I can't figure out how to map the I/O's for E-stop and home-
swiches and so on. Maybe that's not ready yet?

thanks
Roger
Re: Maping I/O on G100?
« Reply #1 on: April 05, 2006, 10:46:12 AM »
It should be ready but I don't have mine hooked up now :( IT well be about a week and I will be able to help you with this...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Maping I/O on G100?
« Reply #2 on: April 05, 2006, 03:38:46 PM »
Hi, I'll wait for you or somone else to test this.
I did play some more with it too night and have several other problem but
after puting in my licence dat-file it seems a little bit better. ???
But I still don't have clue about the I/O's, but there's no rush just have on my desk.  :D
Roger
Re: Maping I/O on G100?
« Reply #3 on: April 05, 2006, 04:49:21 PM »
I just got done the bench testing and have moved on to putting it in a machine :) I have started to wire the mill so I hope it is not going to be to long ...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Maping I/O on G100?
« Reply #4 on: April 07, 2006, 12:19:45 AM »
i think it's port 0 then input pin number for version .10, and it's port 1 then input pin number for version.25 and later.  it took me awile but art mentioned it on the yahoo group it was changed to support mod-io board.