2631
General Mach Discussion / Re: Interfacing a Plasma THC into MACH3 \ Ok To Move
« on: July 07, 2006, 08:46:37 PM »
To get it to stop with the state of a pin can be done by doing the following:
Under Config/Logic check the "Program Safety Lockout" and set the pin that you would like to start and stop the motion as the external activation #1
The Debounce is set under Config/State
Hope that helps
Brian
Under Config/Logic check the "Program Safety Lockout" and set the pin that you would like to start and stop the motion as the external activation #1
The Debounce is set under Config/State
Hope that helps
Brian