Hello Guest it is April 23, 2024, 05:57:18 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Help using cutting fluid pump command (M7,8,9) to activate a switch  (Read 2617 times)

0 Members and 1 Guest are viewing this topic.

Offline widpyro

*
  • 91 91
    • View Profile
    • CT Pyro Mfg LLC
Help using cutting fluid pump command (M7,8,9) to activate a switch
« on: July 07, 2006, 06:59:26 AM »
What is the procedure for activating the M7,8,9 commands to activate a switch?Thanks
Logged

Offline Brian Barker

*
  • *
  • 3,859 3,859
    • View Profile
Re: Help using cutting fluid pump command (M7,8,9) to activate a switch
« Reply #1 on: July 07, 2006, 08:52:15 AM »
M7 and M8 are going to be the flood and mist outputs. you have to set them up with an output pin and set that pin to the macro under the spindle settings in mach3 (under the ports and pins) and it is some place off the config menu in Mach2.
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Pages: 1   Go Up
« previous next »