Messages

2471

General Mach Discussion / Re: Non persistance when doing config setup

« on: July 28, 2006, 11:43:49 AM »

You can change the Home Negative  state under the config/ Homing and Limits

Hope that helps
Brian

2472

Show"N"Tell ( Your Machines) / Re: John S Seig X3 conversion

« on: July 28, 2006, 08:30:51 AM »

AHHA!! I think I know what software it is

2473

G-Code, CAD, and CAM discussions / Re: Is any one using Fearture Cam?????

« on: July 28, 2006, 08:28:12 AM »

Here you are Nice to see others using feature cam... I have been using it for 8+ years 

2474

G-Code, CAD, and CAM discussions / Re: Small z-axis movements during cycle - DRO does not change

« on: July 28, 2006, 08:25:31 AM »

Could you please tell me what program you were running? I try to keep a list in my head of "problem software"

2475

G-Code, CAD, and CAM discussions / Re: Quirky results from G2 command - help a newbie!

« on: July 28, 2006, 08:23:59 AM »

It is free in the latest version of Mach3 Just look under File at the top of mach 3 .

2476

General Mach Discussion / Re: Error history

« on: July 28, 2006, 08:22:33 AM »

Sorry there is no way to do that

2477

General Mach Discussion / Re: What kind of relay to use.

« on: July 28, 2006, 08:21:52 AM »

I use the 5-24VDC input SSR's

2478

General Mach Discussion / Re: Mach 3 computer requirements, network compatibility

« on: July 28, 2006, 08:14:29 AM »

Off the record I will tell you that I have done exactly what you would like to do I say set it up and see what happens...

I would get the best PC that I can get for the money... Don't go to nuts 

2479

General Mach Discussion / Re: Problem with the integration of thc300

« on: July 28, 2006, 08:12:03 AM »

It sounds like you have some THC settings that are not setup right You will need to contact them about the settings. I don't have one of there boards here to test with.

Thanks
Brian

2480

General Mach Discussion / Re: Non persistance when doing config setup

« on: July 28, 2006, 08:09:21 AM »

Change the setting close the Homing and limits dialog. Then you need to close Mach3. By closeing Mach3 you are backing up all the settings.

That should work