3651
General Mach Discussion / Re: Cutter radius comp problem
« on: January 04, 2006, 07:10:56 AM »Brian you wrote "You can use the auto d = tool that you have in mach3... "Sorry about the the mouse on the computer I was on jumps around and I edn up with words in strange places at times....
is that in mach or in the postprocessor?
About the tool table I understand the tool lenght and wear but does it matter
what I type in tool diameter column?
Roger
The auto D Val is in Mach3
As for the tool table you only need to have the Dia of the tool IF you are going to call it with a G41 or G42.
Hope that helps
Brian