Messages

1431

LazyCam (Beta) / Re: Confused about LCAM versions

« on: March 23, 2007, 08:00:54 PM »

Sorry about all that  We are working very hard to get this all sorted out at this time and hope to have something that will help everyone in the very near future. (With good Rev numbers Too!)

Thank you and sorry about that
Brian

1432

General Mach Discussion / Re: mpg and mach 3

« on: March 23, 2007, 07:55:32 PM »

Don't use the Ipac with the MPG ...  I am not a fan of the Ipacs as I have had a few give me a very hard time with noise and so on I think the Mod IO is a better way to go.

1433

General Mach Discussion / Re: mach 3 rev2,057 troubles

« on: March 23, 2007, 07:53:16 PM »

What do you see in the Time in Int DRO on the diagnostics screen? That will tell us if the driver is running. Also we should check to see that you have the driver installed in device manager. You should see Machd Driver under the Mach X Pulsing Engines. Do you see that? If not you need to reinstall (Don't bother to uninstall) When you are installing please be sure that you don't uncheck anything during the install. Also post you XML and let me see that you are not trying to run something like an NCpod... that will stop the driver from running.

Thanks
Brian

1434

General Mach Discussion / Re: Z axis problem

« on: March 23, 2007, 07:45:17 PM »

Tell me if that is the problem I am starting to think you may have a bad cable or some thing like that ...

1435

LazyCam (Beta) / Re: can't change cutdepth, feed rate, etc.

« on: March 22, 2007, 08:54:55 AM »

Please get the newest version of Lcam and we will see if we fixed that problem

Thanks
Brian

1436

LazyCam (Beta) / Re: Duplicate, move and rotate

« on: March 22, 2007, 08:53:21 AM »

Not in Lcam at this time

1437

General Mach Discussion / Re: mpg and mach 3

« on: March 22, 2007, 08:49:41 AM »

That is odd... I have never seen that. The only thing that I can think is that you have a hot key set and you don't know it

1438

General Mach Discussion / Re: Z axis problem

« on: March 22, 2007, 08:46:25 AM »

Could you tell us what you are using for a breakout board? also sherline mode and see if that helps at all

1439

General Mach Discussion / Re: Z Axis Drift Problem...Losing Counts on a Servo System?

« on: March 22, 2007, 08:42:33 AM »

Did you get the cable drivers for the US Digital encoders? I Have had problems in the past with noise on the encoder lines if I didn't use them (They are only about 10.00USD)

1440

General Mach Discussion / Re: About Precision Ref point

« on: March 22, 2007, 08:40:44 AM »

I am on the road today but as soon as I get back I will help you with this.