Messages

3701

General Mach Discussion / Re: Touch Screens

« on: December 13, 2005, 10:05:42 AM »

I have one running here and the feed back for the screen is USB... Works GREAT!!!

Thanks
Brian

3702

General Mach Discussion / Re: Mach 3 Hotkey list

« on: December 12, 2005, 02:11:51 PM »

Sorry I don't have them

I would give it to you if I did...
Brian

3703

General Mach Discussion / Re: Mach 3 Hotkey list

« on: December 12, 2005, 12:37:56 PM »

Look at the Customizing manual on pg.51 there is a list of the hotkeys.

Hope that helps
Brian

3704

General Mach Discussion / Re: Mach 3 Hotkey list

« on: December 12, 2005, 10:23:47 AM »

I think you will find that in the mach2 manual. We made them all the same

Thanks
Brian

3705

General Mach Discussion / Re: NFS question

« on: December 12, 2005, 10:21:53 AM »

The arcs that are making the cut is not a true spiral... Atrue spiral would have to be a bunch of VERY small moves:) As for the % tool Dia ... it is going to change a bit from the start to the end due to the fact that you can't start the cut without taking 100% of the tool.

Hope that helps just a little.
Thank you
Brian

3706

General Mach Discussion / Re: Threading wizard

« on: December 11, 2005, 12:24:26 AM »

I see I was thinking bout thread milling :-)


It is on the list and I think it is going to be soon

Brian

3707

General Mach Discussion / Re: Threading wizard

« on: December 10, 2005, 03:57:20 PM »

Sorry, what threading wizard are you talking about?? the one in the NFS wizard ot the turn wizard?

I fixed the one in the turn wizard but not the NFS... I didn't think there was a problem in the NFS wizard. I will fix it ASAP if you tell me more.
Thank you
Brian

3708

General Mach Discussion / Re: 1000 CPR encoder

« on: December 10, 2005, 07:00:01 AM »

There are machines that do this. It is not the best way but if you have a zero backlash belt drive or coupling it should work. That said the best way is to change the encoder.

Hope that helps
Brian

3709

General Mach Discussion / Re: Ignore Tool Change

« on: December 09, 2005, 05:15:12 PM »

I didn't even think of the one on the settings page!

Thank you Very good to know!
Brian

3710

General Mach Discussion / Re: Multi Pass Wizard

« on: December 09, 2005, 02:11:11 PM »

No problem! I do the same thing all the time....


Thank you
Brian