Hello Guest it is July 17, 2019, 01:15:16 PM

Author Topic: 1000 CPR encoder  (Read 3210 times)

0 Members and 1 Guest are viewing this topic.

1000 CPR encoder
« on: December 09, 2005, 08:40:32 PM »
I have a 1000 cpr encoder on my X servodrive running at 2700 rpm. I need to know if I move the encoder to a shaft on the same X drive that only runs 245 rpm, will it work or will i need a different cpr encoder.

              cncnut
Re: 1000 CPR encoder
« Reply #1 on: December 10, 2005, 07:00:01 AM »
There are machines that do this. It is not the best way but if you have a zero backlash belt drive or coupling it should work. That said the best way is to change the encoder.

Hope that helps
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com