Messages

2401

General Mach Discussion / Re: Just introducing myself

« on: August 15, 2006, 09:10:29 PM »

This is how a Gcode line will look with the feed rate
G01 X1.0 F30.0


I use the USB jump drives to move the programs But you can do what you are thinking!

2402

Newfangled Solutions Mach3 Wizards / Re: Cut Gears alteration

« on: August 15, 2006, 03:02:59 PM »

Thank you, I will look into it

2403

General Mach Discussion / Re: Anaheim Automation DPD21AA1 Translator

« on: August 15, 2006, 03:01:14 PM »

It should work....

2404

General Mach Discussion / Re: Can use both LTP Port

« on: August 15, 2006, 02:56:29 PM »

That sounds about right

2405

Newfangled Solutions Mach3 Wizards / Re: Cut Gears alteration

« on: August 15, 2006, 05:50:38 AM »

Could you please give me an example of the Gcode that you would use to do that?

2406

General Mach Discussion / Re: Tracing eye and mach

« on: August 15, 2006, 05:47:42 AM »

You are not going to be able to use the bunny  controle we could (If given the time) use a $10 web cam to teach in a part This is something that I have been thinking about and just have not had  the time to even think about iit

2407

General Mach Discussion / Re: Just introducing myself

« on: August 15, 2006, 05:42:47 AM »

Could you please set up Mach3  If you have mach 3 running you can use the wizards to make gcode! by reading the Gcode and watching the machine run you will get good at Gcode fast

I think you needed to add an F30.0 to your program.. that wouls tell it to move at 30 units/min

Hope that helps
Brian

2408

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 15, 2006, 05:38:08 AM »

Okay,
Chip and John I should have time to get that all working tonight. I worked with Art last night with Art on the multiaxis probing So i will stop working on the toys and get back to work 

I am off Thursday (from work) so I better have it fixed this weekend!

2409

General Mach Discussion / Re: mach3 not saving my x and z

« on: August 14, 2006, 10:05:42 PM »

There is a check box under the State "copy G54 from G59 P 253 on start up" or something like that... optinal offset save and so on is there as well

2410

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 14, 2006, 09:57:02 PM »

Cool I will work on that tomorrow

Thank you
Brian