Messages

1351

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: April 04, 2007, 09:59:38 PM »

To bad you were not in Maine! we could both look at something and say... man that looks heavy! I think we need the tractor  

Sorry to hear about the back and please have fun with the software!

Brian

1352

General Mach Discussion / Re: Set Z to zero automatically?Auto tool zero questions

« on: April 04, 2007, 09:56:10 PM »

Okay some one please post this in a place that everyone can find it !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

or just keep a link to it

1353

General Mach Discussion / Re: Xylotex help needed - newbe

« on: April 04, 2007, 09:55:00 PM »

sounds like you need to revers your step and direction pin (I have done that )

1354

General Mach Discussion / Re: Output issue

« on: April 04, 2007, 09:48:31 PM »

Check with a meter at the port.. that is strange to have all others work and one not.

1355

General Mach Discussion / Re: Driver Fault

« on: April 04, 2007, 09:45:36 PM »

We set them up as an Estop... but if you wanted you could do the following:

   If (OEMTrig3 and getLED(0)) Then
       doButton(21)
       MsgBox("Drive crapped out")
       Exit Sub
   end if


You would put this code in the macro pump

Thanks
Brian

1356

General Mach Discussion / Re: Reverse Run and 'Radius to end of arc differs from radius to start' problems

« on: April 04, 2007, 09:34:52 PM »

Check your license file.. do you see Demo mode? If so you need to register the software to get that function.

1357

General Mach Discussion / Re: Wabeco F1210E retrofit?

« on: April 04, 2007, 09:28:03 PM »

If you use the PMDX board there are very few wires

1358

General Mach Discussion / Re: Mach and External Motion control devices

« on: April 04, 2007, 09:20:27 PM »

Wayne,
I am started back on the Delta Tau! and I am thinking that I need to buy a Galil to test threading...  after I have that done I think your China card is about top of the list! I like the idea of a nice inexpensive card!

1359

General Mach Discussion / Re: Mach and External Motion control devices

« on: April 04, 2007, 09:17:19 PM »

I "think" it will ...

1360

Mach3 and G-Rex / Re: GRex motor tuning and general configuration ?

« on: April 04, 2007, 05:31:50 PM »

The arrow up and down thing in the motor tunning  is not working in the plugins It is because you have to write it to the device and reboot to test...

We are looking at splitting up the docs and making a set for running the software and a set for setting up the software...