Messages

691

General Mach Discussion / Re: Constant velocity

« on: September 27, 2007, 08:22:24 AM »

Go to Config/ General Config and there are CV settings there...

692

General Mach Discussion / Re: video problem

« on: September 25, 2007, 09:08:45 AM »

Can you get drives for it??? there is not much that I can do to fix that one ;(

693

General Mach Discussion / Re: lazycam pro

« on: September 25, 2007, 09:04:59 AM »

Can you break the elipse into lines and save it like that???

thanks
Brian
 

694

General Mach Discussion / Re: Constant Velocity Changed Recently

« on: September 25, 2007, 08:59:33 AM »

Sorry I did not post on this... My ISP was having trouble and I was down for 4 days

Happy to hear that you got it fixed !

Brian

695

General Mach Discussion / Re: OEM Code 352, 353, 354 and 355

« on: September 25, 2007, 08:55:36 AM »

Could you tell us a bit more about what you are trying to do??
Thanks
Brian

696

General Mach Discussion / Re: Modio for inputs/outputs only - No motors.....

« on: September 25, 2007, 08:54:44 AM »

Sounds like a PLC would be the best for that application...

Thanks
Brian

697

General Mach Discussion / Re: CANNED G77/G78 LATHE CYCLE HELP??

« on: September 25, 2007, 08:41:22 AM »

After looking at the macro I can see that I put in the data to show you how to use the Macro's
' G77   
'(Xx.*********x XDia NEEDED)
'(Zx.*********x End Z NEEDED)
'(Fx.*********x Feedrate)
'(can be Set In the settings page: 'Hx.*********x Depth of cut)
'(Cx.*********x Clearance In the X)
'(Qx.*********x Clearance In the Z)
'(Kx.*********x ZStartpoint)
'(Rx.*********x XStartpoint)
'(Tx.*********x Taper In Deg)   

'G78
'(Xx.*********x XDia NEEDED)
'(Zx.*********x End Z NEEDED)
'(Fx.*********x Feedrate)
'(can be Set In the settings page: 'Hx.*********x Depth of cut)
'(Cx.*********x Clearance In the X)
'(Qx.*********x Clearance In the Z)
'(Kx.*********x ZStartpoint)
'(Rx.*********x XStartpoint)
'(Tx.*********x Taper In Deg)

Hope that helps
Brian

698

General Mach Discussion / Re: CANNED G77/G78 LATHE CYCLE HELP??

« on: September 25, 2007, 08:38:20 AM »

It has been years since the last time I looked at that code It would take me about an hour to get you the info for the "stock" can cycles... I would just play with it and see how it works at this point... I will see if I can find the time to look at the macro.

Thanks
Brian

699

General Mach Discussion / Re: circles -- oval shape

« on: September 22, 2007, 07:26:12 PM »

We tested the mill here and we are not seeing the problem that you are having... Could you please check that the axis is square.
Thanks
Brian

700

General Mach Discussion / Re: HELP please Mach3 won't run my board

« on: September 22, 2007, 07:19:26 PM »

Sounds like you need to reverse your Step and direction pins...