Messages

3331

General Mach Discussion / Re: Jogging

« on: March 27, 2006, 07:08:47 PM »

Is Jog mode on? it should be on the screen at the bottom.

Please post your XML if you could

3332

LazyCam (Beta) / Re: Can't download Lazy Cam

« on: March 27, 2006, 07:05:50 PM »

You should be able to download it... I will be updateing it soon

3333

General Mach Discussion / Re: LIMIT I/O how ?

« on: March 27, 2006, 06:59:24 AM »

Ther are outputs called Enable1-6. The output of this is to turn on and off your Drives. Have you had a look at the video's on how to test up mach? There is a good one on setting up the limit switches. 

3334

General Mach Discussion / Re: Jogging

« on: March 27, 2006, 06:56:56 AM »

Press the "Tab" key and check you slow jog %

3335

General Mach Discussion / Re: Recommended PC Configuration

« on: March 27, 2006, 06:54:48 AM »

I would not go lower than about 1 GHz ... I have one running in the shop and it has been doing a great job!

3336

General Mach Discussion / Re: rebooting problem

« on: March 27, 2006, 06:53:12 AM »

Did you reboot after the first install?

3337

General Mach Discussion / Re: Help with Position of Home and Piece Part

« on: March 27, 2006, 06:50:34 AM »

Okay I think I am starting to see where your problem is... If you press Page Down is the spindle going down? are the numbers gettng more negitive?
Thanks
Brian

3338

General Mach Discussion / Re: Macropump

« on: March 27, 2006, 06:44:15 AM »

I will see if there are any calls to get the data.

3339

Mach3 and G-Rex / Re: Mach 4

« on: March 27, 2006, 06:42:52 AM »

I would think it should be working in about 4 weeks or so... IT could be longer as it is not at the top of the list.

3340

General Mach Discussion / Re: Help with Mach3Mill Motor Tuning

« on: March 26, 2006, 06:19:37 AM »

Did you do the driver test?