Messages

2551

General Mach Discussion / Re: need help

« on: July 17, 2006, 07:18:39 PM »

Check your steps per unit. See if one of them is set to zero. If it is set to zer change it to 20000.

See if that helps

2552

General Mach Discussion / Re: Dwell question

« on: July 17, 2006, 07:16:48 PM »

You will need to put it in a macropump...

It will look like this:

If GetLED(13) Then
ActivateSignal(OUTPUT1)
else
DeActivateSignal(OUTPUT1)
End if

2553

General Mach Discussion / Re: Configuring mach

« on: July 17, 2006, 07:11:25 PM »

Good work! 

2554

General Mach Discussion / Re: Pulse Frequency Slow down

« on: July 17, 2006, 07:10:33 PM »

That would do it! do you have on-board graphics?

2555

General Mach Discussion / Re: upgrading to newest ver.042 and prob ,no driver loaded "run driver test"

« on: July 16, 2006, 07:06:16 PM »

Just reinstall ...

2556

General Mach Discussion / Re: Upgrade - now dead!

« on: July 16, 2006, 07:05:27 PM »

It is called Mach1Lic.dat and it is in the Mach3 directory

2557

General Mach Discussion / Re: Upgrade - now dead!

« on: July 16, 2006, 05:30:45 PM »

uninstall the software and uninstall the driver manualy. there is a section in the manual that will tell you how to do this step by step. If you still can't get it we will dig a little deeper.

2558

General Mach Discussion / Re: upgrading to newest ver.042 and prob ,no driver loaded "run driver test"

« on: July 16, 2006, 05:27:55 PM »

did you uninstall the driver?

2559

General Mach Discussion / Re: Configuring mach

« on: July 16, 2006, 11:47:25 AM »

The direction pin is not set right Did the engineer get back to you?

2560

General Mach Discussion / Re: Pulse Frequency Slow down

« on: July 16, 2006, 11:45:58 AM »

That is not that good You may need to reinstall windows...