i upgraded to the newest version,i was having problems when moving the y axis seemed almost always in the neg. Dir the x axis would step like 1 pulse not sure what direction when this happened,and never thought to check the drive Dir signal line to see if it was hi or low and after the x stepped to see it changed,a least i would know if it was emi or mach was changing the Dir and the step lines to move the x axis,but prob not switching both lines,I'll have to scope all lines and look at there condition,but i thought I'd post this as i seen another post about the x stepping and he changed the computer and this fixed the problem.
But anyway the main prob is upon loading the newest ver the driver seceded window never comes up and a window comes up saying driver not loaded (something like that) an i should run the driver test,will when i run that it says i should run the driver test?
i went back to the old version and now it says the same thing?
Erik