Messages

1081

General Mach Discussion / Re: step rate on maxnc ol

« on: May 27, 2007, 01:36:14 PM »

Please change your Motor tuning settings under Config / motor tuning

Thanks
Brian

1082

General Mach Discussion / Re: Emergency stop not working

« on: May 27, 2007, 01:33:06 PM »

This was fixed off line and  the problem was that the tool will not pickup if you hit the reset button... only the stop button.

(Wanted to have this if any other people had the same  question )

1083

General Mach Discussion / Re: I need help in Screen4.

« on: May 27, 2007, 01:30:58 PM »

I am confused... Why do I need Gcode if the Pause LED is not working in Screen 4 ? Is Pause working on this file?

1084

LazyCam (Beta) / Re: LazyCam Icons

« on: May 27, 2007, 01:27:36 PM »

Great work!!!! We NEED to add them !


Thank you Paul

Brian

1085

LazyCam (Beta) / Re: Lcam 2.0...

« on: May 27, 2007, 01:23:34 PM »

Please Post the DXF and i will have a look at it ...

Are you talking about rotating the view or the drawing?

1086

LazyCam (Beta) / Re: engrave picture????

« on: May 27, 2007, 01:21:30 PM »

Joe,
Nice to see you are working this weekend ... Gary Told me you were up and running with the New router! 

I don't know where there are anypics of a pic that has been done as I don't keep that stuff I do know that it works because I have tested it but other then that you may have to take a chuck of junk wood and run a small file for testing.. If there is anything that I can help you with please feel free to post all you like.
Thanks
Brian

1087

General Mach Discussion / Re: Odd spacebar behavior?

« on: May 23, 2007, 06:11:11 AM »

I am out on the road today but after I get back I will have a look
Thanks
Brian

1088

LazyCam (Beta) / Re: Lcam Rev 2.02

« on: May 22, 2007, 11:04:33 PM »

Found the problem and I will upload it to the web

Thanks
Brian

1089

LazyCam (Beta) / Re: Lcam Rev 2.02

« on: May 22, 2007, 10:53:39 AM »

Okay I will have a look at the file
Thanks
Brian

1090

LazyCam (Beta) / Re: Tab Feature

« on: May 22, 2007, 09:39:44 AM »

That is okay... it is just a tool at this point for testing the math that I have done, I have not added any error checking