Messages

3231

General Mach Discussion / Re: Irregular circles

« on: April 13, 2006, 07:25:21 PM »

Could you please post a pic of what it is doing?

3232

General Mach Discussion / Re: Problem with extra Parrallelports

« on: April 13, 2006, 12:45:25 PM »

Hello Dave,
All you have to do is type in one of the BC00-BC07, B800-B807, B400-B407, B000-B007,AC00-AC07, A800-A80 into the ports  in Mach3. You will have to test each one to figure out what one is going to work

3233

General Mach Discussion / Re: big speed control knob

« on: April 12, 2006, 07:27:53 AM »

I have done this with a PLC but you should also be able to do it with a ModIO card as well...

3234

General Mach Discussion / Re: Automatic tool change for router table

« on: April 12, 2006, 07:26:14 AM »

Read a little in the forums a newfangledsolutions.com and  you will see where I did son VB examples to help you get started. I don't get over to that page that often but ifyou post here I will be back with you ASAP.

3235

General Mach Discussion / Re: Reversing Motors?

« on: April 11, 2006, 08:18:54 PM »

Hop on MSN messanger and I will change the settings for you an other way.

3236

General Mach Discussion / Re: Computer crashing when using Mach2

« on: April 11, 2006, 07:46:49 PM »

Please look into this http://www.machsupport.com/optimisation%20XP.txt

3237

General Mach Discussion / Re: Lost Mach3 Gecko 201

« on: April 11, 2006, 11:48:50 AM »

Hello Ed,
Go to the Motor tuning page and set the accel and Vel. IF you click on the graph then press teh up and down arrows to jog the selected axis to test the motor. Please have a look at the video's (there is one on setting up your motors).

3238

General Mach Discussion / Re: mach2 but not mach3?

« on: April 11, 2006, 11:46:05 AM »

Great you are going to have chip all over the shop in no time

3239

General Mach Discussion / Re: Message line="Safe Z turned off-ignoring safe z move" but it's not turned o

« on: April 11, 2006, 11:44:38 AM »

I don't use the safe Z stuff What are you trying to have it do?

3240

Works in progress / Re: New 3 Axis and 5 axis Screen

« on: April 10, 2006, 08:02:17 PM »

Well I am ticked!!!! I can't do that!!! Man I wish I could!

Nice work!

Thanks
Brian