I would like to setup automatic tool change for my router table (vacuum collet style), i understand this is possible, so i wouldnt have to write the motions and relays into the actual g code. Instead preset tool change motions are some kind of subroutine( i presume).
Also what is meant by VB?
Can anyone shed some light on how i should start going about this.....

benergy

Read a little in the forums a newfangledsolutions.com and  you will see where I did son VB examples to help you get started. I don't get over to that page that often but ifyou post here I will be back with you ASAP.