Show Posts

3151

Works in progress / Re: An unfinished screen set - "Mach Blue"

« on: April 23, 2006, 07:59:54 PM »

If he gets stuck on screen 4 skip it and and make a list of what needs to be fixed. I willl help you by doing anythign that you can't get to work

3152

LazyCam (Beta) / Re: not generatig a contious cutting path.

« on: April 23, 2006, 07:43:05 PM »

Gerry thank you for looking at that. I have been working on Gerber files and have not had the time to look at that other file (Hard to change once you are started on a bit of code...)

3153

General Mach Discussion / Re: What's the best way to determine motor velocity?

« on: April 23, 2006, 07:37:05 PM »

Try this and see how you like it... after that we will see if there is more that we can do.

Go under Config/State and check Run Macro Pump take the Macro pump file that I sent to you and put in the Mach3/Macro/Mach3mill. once you have done that close the program and restart Mach3. you should be good to go after that....

3154

General Mach Discussion / Re: Determining Servo Motor sizes

« on: April 23, 2006, 06:33:20 PM »

I think you are going to have to look at the motors that I have just put on. http://web1.automationdirect.com/adc/Shopping/Catalog/Motion_Control/Servo_Systems/Medium_Inertia_(1KW_-_3KW)_Servo_Systems/1KW_Servo_System_(Med_Inertia)

3155

General Mach Discussion / Re: rapid travel problem

« on: April 23, 2006, 06:28:47 PM »

Okay so I think you are going to have to slowdown a bit... What is your FRO set to ?

3156

General Mach Discussion / Re: tangential movement

« on: April 23, 2006, 06:19:32 PM »

Hello Steve there is a setting under "settings" page where you can turn on tangential control. This will turn the A axis as the machine moves around the file...

3157

Works in progress / Re: An unfinished screen set - "Mach Blue"

« on: April 23, 2006, 09:43:42 AM »

If you guys get this up and working I will make an install file for it! if someone wanted to have that screen set thay would just have to download and install.

3158