Messages

3051

G-Code, CAD, and CAM discussions / Re: regarding z axis jog while running

« on: May 04, 2006, 06:57:47 PM »

Small unmarked bills

3052

General Mach Discussion / Re: What's the best way to determine motor velocity?

« on: May 04, 2006, 06:56:59 PM »

I Like to post my program VERY close to the cut rate that I wish to use... I never go over 150% because there is no need... That is just me.

3053

General Mach Discussion / Re: What is a CHARGE PUMP?

« on: May 04, 2006, 06:54:13 PM »

You know you are right  I don't know why I was thinking macro pump...

thank you for setting me straight

3054

General Mach Discussion / Re: How do I activate "allow block delete"

« on: May 04, 2006, 06:52:42 PM »

no problem, I do the same thing 

3055

General Mach Discussion / Re: Plasma cutting only

« on: May 04, 2006, 06:51:56 PM »

I did a wizard set for Plasma But i never released it... There needs to be more hours in a day... What are you looking for?

3056

LazyCam (Beta) / Re: Help with LazyCam

« on: May 04, 2006, 12:27:24 PM »

I have been fixing bugs and that one is on the list...
Thank you

3057

G-Code, CAD, and CAM discussions / Re: Mach3 Random M98 Behaviour

« on: May 04, 2006, 07:01:15 AM »

Take out the "%" They are not used in Mach3. See if that helps at all.

3058

General Mach Discussion / Re: Home switch position

« on: May 04, 2006, 06:58:57 AM »

Please post your XML and i will have a look at it

3059

General Mach Discussion / Re: plasma floating z zero offset

« on: May 04, 2006, 06:57:17 AM »

I think I see the problem... the home Offset is NOT going to move the axis. It is going to tell the Axis how far from the switch it is. If you are looking to have the torch find the place you can use a G28.1 (I think). Is there anything like that coming out of sheet cam?

3060

G-Code, CAD, and CAM discussions / Re: regarding z axis jog while running

« on: May 04, 2006, 06:53:00 AM »

There is a THC active that needs to be active as well. It is on the ports and pins page under the inputs.

To jog the Z in a program you need to use THC up and THC down under the inputs...