Messages

3641

General Mach Discussion / Re: Zero Return (Home Setting)

« on: January 08, 2006, 07:44:10 AM »

Mach3 is going to be looking for the change in state of the home switch. It will hit the switch and then back off the switch till it chages state again.
You will be able to do homeing with the index pulse with the Grex in the future.

Hope that helps

3642

General Mach Discussion / Re: Eureka I've Got Mill

« on: January 07, 2006, 08:58:35 PM »

GOOD!!!

You are going to be cutting parts in no time 

Good job, we knew you could do it.

3643

General Mach Discussion / Re: LCD / LED fonts for download.

« on: January 07, 2006, 08:11:18 AM »

Very nice Benny! This is going to be cool:)

3644

General Mach Discussion / Re: Got my IKO slides in !!!

« on: January 07, 2006, 08:08:42 AM »

Very NICE!!! You are going to need to have some LARGE motors for that!

Looks like fun

3645

General Mach Discussion / Re: More Rotary confusion

« on: January 06, 2006, 01:44:45 PM »

IT sounds like you should change your motor tune settings. Please back down you Max Vel and Accel. Keep doing this till you can run that little file.

Thank you

3646

General Mach Discussion / Re: More Rotary confusion

« on: January 06, 2006, 05:38:37 AM »

Try running this :
G00 A 0.0
G91
A180.0
M00
A-180.0
G90


This will tell if your axis is having a problem, you shoud see it move 1/2 a rev wait for a cycle start and go back to the start point.

Thank you
Brian

3647

Mach3 and G-Rex / Re: G-Rex

« on: January 05, 2006, 07:08:32 AM »

I don't have a GRex here so I can't help you with this... Art has been working on  it, I will get a stat report from him and get back to you

3648

General Mach Discussion / Re: Any one have a source for flexable wire and cable tray?

« on: January 05, 2006, 07:03:29 AM »

Try looking for this "flexible wire raceway"
Here is a page to look at http://www.igus.com/echain.asp

3649

General Mach Discussion / Re: big router vacuum tables ?!?

« on: January 04, 2006, 03:19:02 PM »

You keep scap to put on the table

3650

General Mach Discussion / Re: Cutter radius comp problem

« on: January 04, 2006, 03:17:35 PM »

Sorry that was my poor atampt at telling you that if you put nothing Mach will put in the D Val for the T number that is loaded.

Sorry again