Messages

2781

General Mach Discussion / Re: Problem with Setup Screen

« on: June 15, 2006, 07:04:42 AM »

it works here Be sure that you are looking at the Axis Pos on the right hand side of the screen.
If it still is giveing you trouble , upload the set file to the forum and i will take a look at it

2782

General Mach Discussion / Re: Help with Write Wizard

« on: June 15, 2006, 07:00:58 AM »

The Write wizard will only do one like at a time I would run the Write wizard a few times, then use copy and past to get the gcode into one file.

2783

General Mach Discussion / Re: Help for macro probe

« on: June 15, 2006, 06:57:46 AM »

I cn help just keep posting questions and we will do the best that we can

The Probe maco that I did will do the following:

1. Drop the tool down till it hits the switch
2. pick the Tool up one unit (1inch in my case)
3 Set the Z postition to 1

Hope that helps
Brian

2784

General Mach Discussion / Re: Ref. All Home - Limit tripped Will not ref.

« on: June 14, 2006, 10:47:35 PM »

Try setting the debounce to about 1500 under the Logic settings

2785

LazyCam (Beta) / Re: trouble with 2.53

« on: June 13, 2006, 04:31:34 PM »

Try running Lcam with out Mach3 running...  Is that any help?

2786

General Mach Discussion / Re: conection for mach3 and Sureservo motors and drives Automation Direct

« on: June 13, 2006, 06:51:40 AM »

I will see if I can get time to draw how I had hooked mine up

2787

General Mach Discussion / Re: Mach/Gecko3x0/ speed limits ?

« on: June 13, 2006, 06:49:38 AM »

Sorry the calcs that I did at first were all based on the 500 line encoder

The 45KHz is per axis so you are okay...

2788

General Mach Discussion / Re: Auto tool height offset measurement

« on: June 13, 2006, 06:46:47 AM »

I can show you what I did and why.. Once I do that you are ready to make your own macro!

sounds like fun!

2789

LazyCam (Beta) / Re: Lazy Cam 2

« on: June 12, 2006, 07:53:45 PM »

I found the problem and I have fixed it

I have a few more things that I am working on so it is going to be a few days till the release is ready..

Just wanted to update you 
Brian

2790

General Mach Discussion / Re: Circular pocket shout out

« on: June 12, 2006, 07:49:46 PM »

Try:
G13 I.5 F10

IF you have the flats it is time to start working on the mill   Check your gibs and see that you have good  nuts on the screws.

Hope we can help!
Brian