Messages

3061

General Mach Discussion / Re: What's the best way to determine motor velocity?

« on: May 03, 2006, 09:12:25 PM »

it will not make the rapids faster but under 100% FRO will slow them down..

3062

General Mach Discussion / Re: How do I activate "allow block delete"

« on: May 03, 2006, 09:11:13 PM »

the LED needs to be on to get it to work...

3063

General Mach Discussion / Re: Missing Steps

« on: May 03, 2006, 09:08:17 PM »

Try putting in a prechange of 5 us as well... What are you running for a breakout board?

3064

General Mach Discussion / Re: Brian...I need your VB expertise Please!!!!!!

« on: May 03, 2006, 04:03:14 PM »

Great job!!!

3065

General Mach Discussion / Re: Missing Steps

« on: May 03, 2006, 02:43:33 PM »

What are the drives?

3066

General Mach Discussion / Re: Home switch position

« on: May 03, 2006, 02:42:29 PM »

Try setting your debouce to 2000 (20us)

3067

General Mach Discussion / Re: Home switch position

« on: May 03, 2006, 06:13:45 AM »

Can you press the switch and see the state change on the Diagnostics page?
Also what do you have for inputs that are active?

3068

General Mach Discussion / Re: plasma floating z zero offset

« on: May 03, 2006, 06:11:15 AM »

Are you running a THC?

3069

General Mach Discussion / Re: Perske Spindle

« on: May 02, 2006, 10:53:30 PM »

You could put on a VFD and have mach3 run the VFD...

3070

General Mach Discussion / Re: BEst controller or driver to use w/mach3

« on: May 02, 2006, 10:52:11 PM »

There are a few on the liinks page... I have not used them (I like big stuff )