Messages

1071

Show"N"Tell ( Your Machines) / Re: Yet another Retrofit. Hardinge HXL-S

« on: May 28, 2007, 10:17:03 PM »

Good looking work !

You will be making chips in no time 

1072

LazyCam (Beta) / Re: Lcam Rev 2.02

« on: May 28, 2007, 10:01:27 PM »

You will need to use the zigzag to get it to work

thanks
Brian

1073

LazyCam (Beta) / Re: LazyCam - newbie questions

« on: May 27, 2007, 08:45:19 PM »

Ken We will add Doc's when we are done working on the software... this is a work in progress and if we made Doc's it would take about 50% of the programing time away to make the doc's. We are not willing to slow the devlopment at this early stage But we will make a few video's showing how to use the software.
Thanks
Brian

1074

LazyCam (Beta) / Re: Not Loading DXF

« on: May 27, 2007, 08:42:50 PM »

To set the depth you need to select the layer in the Tree on the left and when you do the layers tab will select at the bottom of the screen. Type in what you woud like the depth to be and press send to layer.
That should do it
Brian

1075

LazyCam (Beta) / Re: Zoom box

« on: May 27, 2007, 08:38:45 PM »

sounds like it is all fixed

1076

General Mach Discussion / Re: step rate on maxnc ol

« on: May 27, 2007, 02:04:58 PM »

Set them to what you feel looks good
It is not the same for all machines

1077

General Mach Discussion / Re: Any networking gurus here?

« on: May 27, 2007, 01:49:41 PM »

Copy over the XML ... you just need to reset the motion device and select the G100

1078

General Mach Discussion / Re: Stop File & M1000 in one button...

« on: May 27, 2007, 01:48:04 PM »

If you would like to stop the file you will need to do a

DoButton(xx)  'xx = the button number found in the customization Wiki

Also you will have to Pause the file first...

Then it will run the code that you would like to do

Hope that helps
Brian

1079

General Mach Discussion / Re: Keygrabber

« on: May 27, 2007, 01:43:57 PM »

You may be best of to use the Joystick plugin ...

1080

General Mach Discussion / Re: tell me about importing a jpeg image and converting it to G-code

« on: May 27, 2007, 01:42:36 PM »

Use Mach3 if you can and it will come with a free version of Lcam. In lcam you can make a file from an image, it is doing this by converting to gray scale and applying depth to the shade of gray... Try it, it is free