Messages

3001

General Mach Discussion / Re: Mach2 works fine but...

« on: May 12, 2006, 10:20:17 PM »

Could you please post your Mach2 XML?

3002

General Mach Discussion / Re: Mach2 works fine but...

« on: May 12, 2006, 10:17:17 PM »

Still looking
 

3003

General Mach Discussion / Re: square threads

« on: May 12, 2006, 09:42:55 PM »

External threads will cut into the part fron out outside. So the rapid moves will pull out in the +X Direction and cutdepths will go more negitive the deeper the thread is cut. The internal threads will rapid back in the -X direction and will advance the cut in the +x direction. I think that is what you were asking ... and to get the wizard to cut an internal thread you just have to give a smaller start dia and a larger end dia.

is that any help?
Brian

3004

General Mach Discussion / Re: Mach2 works fine but...

« on: May 12, 2006, 09:37:24 PM »

Try this one..

3005

General Mach Discussion / Re: square threads

« on: May 12, 2006, 09:16:24 PM »

If you have any trouble I will be up and about for a few more hours 

3006

General Mach Discussion / Re: Mach2 works fine but...

« on: May 12, 2006, 09:13:44 PM »

Could you pleawse post your XML and I will have a look at it..

3007

General Mach Discussion / Re: square threads

« on: May 12, 2006, 09:11:51 PM »

Change the infeed angle to zero and you should be good to go

3008

General Mach Discussion / Re: my first retrofit with mach3, please help

« on: May 12, 2006, 04:52:27 PM »

use the limit switches to home the mill and the softlimits will do the rest

3009

LazyCam (Beta) / Re: Lazy Cam 2

« on: May 12, 2006, 11:45:04 AM »

I think it is a bug I will hav to look at the output class.

Thank you
Brian

3010

General Mach Discussion / Re: unknown problem with arcs

« on: May 12, 2006, 06:59:46 AM »

Could you please post and example of the few lines of code that are giving you trouble?
Thank you