Messages

2881

Mach Screens / Re: Starting A Wizard

« on: May 31, 2006, 11:59:46 AM »

I do the screens in 1024

There is a Save Current Layout under the View in mach3..

Hope that helps
Brian

2882

General Mach Discussion / Re: Bug in Mach 3 or Bug in Me?

« on: May 31, 2006, 11:51:27 AM »

G91.1 is to tell Machs3 that the arc's are done in Inc IJ mode

2883

General Mach Discussion / Re: Multipass in Mach3Turn

« on: May 31, 2006, 11:50:12 AM »

Hello Edward,
There is not a multi pass wizard for turn in the next 6 months we are in hopes to put turn into Lcam.

Sorry
Brian

2884

General Mach Discussion / Re: Machine Interference

« on: May 31, 2006, 11:48:39 AM »

What end did you ground? What ground did you hook the one end to? is there more than one shield in thecable? How long are the wires?

2885

LazyCam (Beta) / Re: Tool Offsets

« on: May 31, 2006, 07:59:27 AM »

I think there is a bug in that section... There is a function that tells if a chain is CW that is not working all the time, I have it about half redone and it "should" fix all the comp problems. It is going to take a little time but I think Iam going to have all the bugs out of lcam in a week or so!

Thanks to all that are helping point them out.
Brian

2886

General Mach Discussion / Re: Machine Interference

« on: May 30, 2006, 11:17:28 PM »

Try running shielded cable on the step and Dir lines... I think that will fix the problem

2887

General Mach Discussion / Re: DXF to G-code oddities (new to this stuff)

« on: May 30, 2006, 11:15:49 PM »

Is this in the old importer or in  Lcam?

Thank you
Brian

2888

General Mach Discussion / Re: Acceleration calculations

« on: May 30, 2006, 08:22:52 PM »

There is a gearing setting that you can tell it for every step that you take in Move 10 pulses... That is going to be noproblem!

If you are going to do the 800in/sec^2 take great care in picking out the parts that it is going to be moving... you are going to be impact loading the chain and it is not going to take long to kill the chian...

This is going to be a cool machine 

2889

LazyCam (Beta) / Re: LazyCam won't load

« on: May 30, 2006, 08:18:43 PM »

Chip I have your bug list out and I have about half of them done now

I tried to make a video but I ran into a few bugs I know when I make this next video Lcam is going to be ready for primetime ! 

2890

General Mach Discussion / Re: Acceleration calculations

« on: May 30, 2006, 02:10:15 PM »

I would look to run it at a bit less than that Tune it in at about 500in/Sec^2 and I think you will be very happy...


Hope that helps
Brian